Bonjour,
Gros problème pour commencer la journée! Lors du changement de mors (longs par des courts) impossible de dévisser un des mors: l'empreinte 6 pans n’accroche plus...
Sur les mors longs les vis sont tout au fond du mors. Je ne sais pas si c'est démontable, s'il existe des pièces détachées?... Merci si quelqu'un à une piste...
>1. Place Chuck Jaws side up on a good bench.
>
>2. Using a round steel bar (ideally a Pin Punch smaller in diameter than
>the screw head itself) place and hold onto the damaged screw.
>
>· An additional person holding the chuck down will help otherwise
>you can place the chuck in soft jaws in a vice.
>
>3. Using a steel hammer whilst holding the Pin Punch on the screw head
>hammer the Punch firmly two or three times. Make sure between strikes of
>the hammer that the pin punch does not move off the screw head as you could
>damage the Jaw.
>*Marco Verrecchia*
Hello Marco,
Thank your for your fast and useful reply.
Using the Pin Punch suggestion, together with 3 days dripping a fluid penetrating lubricant on the blocked screws, I have been able to remove these two screws, the fist one with an Allen key, the second one with a screw extractor. Having also been able to get replacement new screws, my chuck is back to perfect condition.
Again many thanks for your help,
--Michel--
Si l'anglais te pose un problème, Google Traduction est ton ami ... et moi en second si besoin.
Bon tournage, bon chantournage à vous tous
roger
Partager...les connaissances, pour mieux travailler... le bois
mettre un mot sur le livre d'or fait toujours plaisir
visiter mon site http://tournebois.free.fr
mail perso roger.vuillermoz@gmail.com
>1. Place Chuck Jaws side up on a good bench.
>
>2. Using a round steel bar (ideally a Pin Punch smaller in diameter than
>the screw head itself) place and hold onto the damaged screw.
>
>· An additional person holding the chuck down will help otherwise
>you can place the chuck in soft jaws in a vice.
>
>3. Using a steel hammer whilst holding the Pin Punch on the screw head
>hammer the Punch firmly two or three times. Make sure between strikes of
>the hammer that the pin punch does not move off the screw head as you could
>damage the Jaw.
>*Marco Verrecchia*
Hello Marco,
Thank your for your fast and useful reply.
Using the Pin Punch suggestion, together with 3 days dripping a fluid penetrating lubricant on the blocked screws, I have been able to remove these two screws, the fist one with an Allen key, the second one with a screw extractor. Having also been able to get replacement new screws, my chuck is back to perfect condition.
Again many thanks for your help,
--Michel--
Si l'anglais te pose un problème, Google Traduction est ton ami ... et moi en second si besoin.
--Michel--
Bonjour Michel et merci pour ton retour,
J'ai commencé par le dégrippant pour 3 jours... Je crains un peu de taper sur la vis au chasse clou sans démonter le mors du mandrin (si possible)...
